Author: "jaybrinkmeyer" <jaybrinkmeyer@...> Time: Sun Dec 5, 2004 4:11 pm PST Link
Randy's tank photos helped me solve a problem with my tank vent lines.
The -10 plans show gromets placed in the aft-most row of holes. When I
ran my 63" vent lines that way two bends were required that caused the
end terminated below the fuel cap to be too short. I saw Randy's
photos and re-plumbed the lines using the aft holes instead. Now I
have ample overage at the fuel cap end and there's better clearance
for the floats...
This afternoon I installed the float sensors. IMHO, the plans were
vague about what goes where - gasket? position on right tank? Perhaps
it's a no brainer to someone who's assembled a tank before, but the
right drawing would have gone a long way. I dug out the archived
resistance posts and that helped too. Once again, Randy's photos of
proper left and right placement saved my bacon.
Regards,
Jay
------------------------ Yahoo! Groups Sponsor --------------------~-->
Make a clean sweep of pop-up ads. Yahoo! Companion Toolbar.
Now with Pop-Up Blocker. Get it for free!
http://us.click.yahoo.com/L5YrjA/eSIIAA/yQLSAA/1yWplB/TM
--------------------------------------------------------------------~-
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/RV10/
<*> To unsubscribe from this group, send an email to:
RV10-unsubscribe@yahoogroups.com
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/