Author: "gingy1raylynn" <gingy1@...> Time: Sat Dec 18, 2004 8:00 pm PST Link
Hello all,
I'm currently countersinking the flanges of the HS spars, and have
noticed that on some, the pieces of aluminum removed will get caught
by the bit, and cause "swirlies" around the holes. Some are not
deep, but some have gone all the way through the primer and put small
gouges in the spars themselves. Did anyone else have this happen to
them (I'm almost certain of it), and should it be anything to worry
about? The plans have you prime the spars already and rivet some
pieces together. i'm planning on priming over the spar assemblies b4
I put the whole thing together.
Also, on the front HS spar, they have you rivet the spar caps in
place with the nine middle flange holes. Then, you put the HS
together and match drill everything. Take everything apart to
deburr, but you can't really get BEHIND the spar caps to deburr the
back of them, and the inside of the spar flange. Anyone else think
of this and concerned. Or, as usual, am I being entirely too anal
again? Like Ken says, "It's nothing complicatted like a car or
anything, it's just an airplane..."
Thanks in advance fellas,
Eric
------------------------ Yahoo! Groups Sponsor --------------------~-->
Make a clean sweep of pop-up ads. Yahoo! Companion Toolbar.
Now with Pop-Up Blocker. Get it for free!
http://us.click.yahoo.com/L5YrjA/eSIIAA/yQLSAA/1yWplB/TM
--------------------------------------------------------------------~-
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/RV10/
<*> To unsubscribe from this group, send an email to:
RV10-unsubscribe@yahoogroups.com
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/