Author: "Paul Walter" <pdwalter@...> Time: Fri Feb 3, 2006 4:26 am PST Link
----- Original Message -----
From: Paul Walter
To: rv10-list@matronics.com
Sent: Friday, February 03, 2006 6:46 PM
Subject: Verticle Stabilizer
Hi Group,
As I am part way through the VS I have run into the same problem as I have read about previously.
Plans say to remove 1/8 inch from VS 1013, VS 1005 and VS 1006 so as not to crease VS 1001 Vertical stabilizer skin with the point of these mentioned ribs
Now, removing 1/8 has done nothing to solve the problem and at this point I have taken 1/4 inch off and when assembled and you look down through top of stabilizer the ribs do not sit flush in front of skin as I would like. It almost seems like these ribs have not be manufactured correctly.
Can the fronts be re fabricated to change the actual shaper of the rib ?.
Thank you
Paul Walter.
[Non-text portions of this message have been removed]
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/RV10/
<*> To unsubscribe from this group, send an email to:
RV10-unsubscribe@yahoogroups.com
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/