Author: "MaxHegler" <MaxHegler@...> Time: Wed Aug 15, 2001 7:36 pm PDT Link
Duh...I don't know why I didn't think of that before...my arms are so tired! Thanks!
Max
----- Original Message -----
From: Luethi, Matt (mailto:mluethi@e...)
To: 'RV7and7A@yahoogroups.com' (mailto:'rv7and7a@yahoogroups.com')
Sent: Wednesday, August 15, 2001 9:21 PM
Subject: RE: [RV7and7A] Preperation for priming
Hi Max, had the same problem then discovered that it comes of with a wet rag, it's water soluble.
Matt
Quote:
-----Original Message-----
From: MaxHegler [mailto:MaxHegler@m...]
Sent: Thursday, 16 August 2001 11:52 AM
To: RV7and7A@yahoogroups.com (mailto:rv7and7a@yahoogroups.com)
Subject: [RV7and7A] Preperation for priming
I have cleaned and scrubbed the parts with scotch brite in preperation for priming. I have no problem getting the sharpie pen markings off but the blue writing that is stamped on the aluminum designating the type is tough stuff. I am somewhat afraid of removing to much material. Is it okay to leave some of the blue stamping showing? I am using Mar-Hyde self etching pretreatment primer. I have read that some folks are just cleaning the aluminum and not "roughing it up"...any comments?
Max
Van's Air Force - World Wide Wing
www.vansaircraft.net
Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service (http://docs.yahoo.com/info/terms/).
(end of quote)
Van's Air Force - World Wide Wing
www.vansaircraft.net
Your use of Yahoo! Groups is subject to the Yahoo! Termsof Service (http://docs.yahoo.com/info/terms/).
(end of quote)