Author: "ianbear99" <ianbear99@...> Time: Wed Jan 2, 2002 2:11 pm PST Link
A while back there was a post regarding priming of the VA-146
elevator bearing, does anyone have any follow up?
Ian Jessen
Author: "ianbear99" <ianbear99@...> Time: Wed Jan 2, 2002 2:15 pm PST Link
A while back there was a post regarding priming of the VA-146
elevator bearing, does anyone have any follow up?
Ian Jessen
Author: "Widebody" <widebody@...> Time: Wed Jan 2, 2002 2:49 pm PST Link
Hi Ian,
If I´m not mistaking, I was the one who asked the question but I decided not to wait for an answer and primed the bearing by simply covering the center with a piece of tape to avoid paint from actually entering the bearing.Just do it lightly and assemble (rivet) the bearing. Came out very nicely on this side of the ocean.
Simon Paul
RV-7A PH-SJP (reserved)
The Netherlands
----- Original Message -----
From: ianbear99
To: RV7and7A@yahoogroups.com
Sent: Wednesday, January 02, 2002 11:11 PM
Subject: [RV7and7A] priming VA-146
A while back there was a post regarding priming of the VA-146
elevator bearing, does anyone have any follow up?
Ian Jessen
Yahoo! Groups Sponsor
ADVERTISEMENT
Van's Air Force - World Wide Wing
www.vansaircraft.net
Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.
[Non-text portions of this message have been removed]