Author: "Kevin" <N90ATC@...> Time: Thu Jun 5, 2003 7:18 pm PDT Link
Just fit my rt. aileron, the left aileron went on just as per plans.
My rt. otbd aileron bracket has a slight inward bend, a little more
pronounced than the left wing's. The only way to make the aileron fit
is to use a small spacer on the otbd aileron bracket on the side
opposite to what the plans call for. Doing this positions the the
aileron properly in relation to the spar. Did anyone else have this
occur?
Author: "Richard & Roberta Hegy" <rhegy@...> Time: Fri Jun 6, 2003 3:27 pm PDT Link
I have QB wings and noticed the right wing Aileron hinge did not fit straight either. It was due to a poor bend in the corner of the outboard rib. I drilled it out and straightened it.
Roberta
----- Original Message -----
From: Kevin
To: RV7and7A@yahoogroups.com
Sent: Thursday, June 05, 2003 8:47 PM
Subject: [RV7Yahoo] Aileron Fit
Just fit my rt. aileron, the left aileron went on just as per plans.
My rt. otbd aileron bracket has a slight inward bend, a little more
pronounced than the left wing's. The only way to make the aileron fit
is to use a small spacer on the otbd aileron bracket on the side
opposite to what the plans call for. Doing this positions the the
aileron properly in relation to the spar. Did anyone else have this
occur?
Yahoo! Groups Sponsor
Van's Air Force - World Wide Wing
www.vansaircraft.net
Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.
[Non-text portions of this message have been removed]